Fermenter - Installing the Thermowell and Thermometer

Jeff Hintt

Last Update één jaar geleden

Installing the Thermowell and Thermometer

Things you'll need

- Thermowell (included)

- Thermometer (included)

- Thermometer to Thermowell Adapter (included)

- Delta Brewing Systems Fermenter (included)


Installing the Thermowell

- Remove the nut from the Thermowell

- Make sure the O-ring stays on the thermowell.

- Find the middle hole just under the Delta Brewing Systems logo and slide the threaded end of the Thermowell through that hole from the inside so that the probe end is inside the fermenter and the threads are on the outside of the fermenter.  Remember to keep the gasket between the Thermowell and the interior wall of the fermenter.


- Reapply the nut to the threaded end of the Thermowell fastening the Thermowell to the fermenter.  It only needs to be finger tight to create a seal, overtightening can crush the gasket and cause leaking.


- Find your adapter (small black grommet with a tiny hole in the center) and press it firmly into the opening of the Thermowell, you'll want this to be snug as it holds your Thermometer and can help ensure a more accurate temperature reading.


- Slide the Thermometer into the grommet until it is fully seated into the Thermowell.


- If done correctly the thermometer should be facing forward and able to provide you with a temperature of the internal contents of the fermenter.

Was this article helpful?

9 out of 9 liked this article

Still need help? Message Us